Announcement

Collapse
No announcement yet.

Newbie help

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Newbie help

    As I posted elsewhere, I am a new owner of an '05 bronze. After taking the hardtop off for the first time, I discovered the scuff marks where the top rests on the car. The Mylar tape packet has apparently never been used. Is there any way to restore the surface with buffing or some recommended cleaning solution?

  • #2
    Re: Newbie help

    If you can feel the scratches with you fingernail they are too deep to buff out. I also have very light problem areas and am preparing to experiment with a fix.

    Going to clean all wax off the area in question and lightly wet sand and spray a thin layer of clear coat....let it cure and again lightly wet sand...Then apply Mother's scratch remover and vigorously buff repeatedly with heavy pressure until I bring back the shine to the clear coat....I feel fairly confident it will work. Going to take before and after pictures and post if successful...

    Comment


    • #3
      Re: Newbie help

      Another alternative would be to cover the scratches with one of these protective trims.

      http://www.thunderbirdconcepts.com/reardeck.htm

      Comment


      • #4
        Re: Newbie help

        Greetings Newb... I have found the SS deck strips work very well that the top sits on. I have them on my car. If you purchas them look ahead at the size. They now have 2 sizes. I have the small width on mine. You can not see them when top is on. Very easy to in stall. good luck on this project...
        sigpic

        Comment


        • #5
          Re: Newbie help

          Greg, you weren't by any chance in the Riverview Tower parking garage downtown earlier this week, were you? I saw a bronze in the garage when I came back from lunch, and I've never seen it in here before.

          Comment


          • #6
            Re: Newbie help

            No, it wasn't me in the Riverview Tower. The week before my car arrived from California, I saw another bronze bird on Lyon's Bend. Fewer than 1400 of them and apparently there are now at least two in Knoxville.

            Comment


            • #7
              Re: Newbie help

              I also recommend this approach as I had the same problem.

              CV

              Originally posted by Randall View Post
              Greetings Newb... I have found the SS deck strips work very well that the top sits on. I have them on my car. If you purchas them look ahead at the size. They now have 2 sizes. I have the small width on mine. You can not see them when top is on. Very easy to in stall. good luck on this project...
              CVCashmere

              Comment


              • #8
                Re: Newbie help

                I was concerned at first and had to buff out some small scratches I keep that area waxed and clean and clean the top gasket good each time. It still loks good and if it eventually looks bad I will put the stainless strips on. The ones I have seen seem like the edges are a little sharp and could use a better finish or buffing on the edge.

                Comment

                Working...
                X